|| The CDM Gear
patent pending BT (boat tail) Wave safety was created to give you a little
more reach and control when activating the safety on your Mossberg 500, 590A1,
930SPX and others. By creating a second contact and control point closer
to the operator, the safety can be rocked on and off more easily without
excessive reach or even taking your thumb off the safety. An aggressive,wide
and deep serration assures grip and control while the tapered, curved rear
deck increases contact awareness in questionable situations. This gives hunters,
3 gunners, security professionals and everyone else increased control in
cold/wet conditions or when wearing gloves. Works with 12 ga. and 20ga. Mossberg
shotguns with a top mounted safety.
| Each CDM Gear
BT Wave Safety comes with a wrench and a screw with included thread locker.
These are all machined from 6061 Aluminum billet right here in the USA.
Installation is simple but taking the factory screw out might be a problem.
We have a video in our video section that shows how we removed the factory
"one way" screw and installed a Delta Wave Safety in just a few minutes.
Pick one up for only