Home     Shotgun Light Mounts    Rifle Light Mounts    Safeties   Accessories   FAQ   Videos  


Home >> Shotgun Safeties >> Delta Wave Safety
      If you are shifting your grip to operate your safety, you have the wrong safety on your shotgun. You need to get low with the wave. We shifted the safety so you can keep your grip and use the power correctly at your thumb. The advantage of the wave design is that the activation angle is low, where it should be. You don't push a car from the roof, right? No, you get low, like a defensive tackle or a sumo wrestler, that's the power range. The offset activation at the rear is your advantage for a better reach without shifting your grip.

     The CDM Gear SL Wave safety was created to give you a little more reach and control when activating the safety on your Mossberg 500, 590A1, 930SPX and others. The SL is all the fit without all the fat. An aggressive ,wide and deep serration assures grip and control while the near traditional size is famailiar but increases contact awareness in questionable situations. This gives hunters, 3 gunners, security professionals and everyone else increased control in cold/wet conditions or when wearing gloves. Works with 12 ga. and 20ga. Mossberg shotguns with a top mounted safety.

     Each CDM Gear SL Wave Safety comes with a wrench and a screw with included thread locker. These are all machined from 6061 Aluminum billet right here in the USA. Installation is simple but taking the factory screw out might be a problem. We have a video in our video section that shows how we removed the factory "one way" screw and installed a Delta Wave Safety in just a few minutes. Your SL Safety will install the same way. Pick one up for only $19.95